Antec nine hundred owners manual

Twelve Hundred. Previous Page. Next Page. Please consult the motherboard manual for specific mounting instructions and troubleshooting.

Before proceeding, check the manual for your CPU cooler to find out if there are steps you must do before installing the motherboard. Lay the case down so that the open side is up. This will allow high speed external hard disk enclosures such as the Antec MX-1 to run at the same speeds as if the hard disk were installed inside the case. Page 6 External 5.

Remove both side panels per the instructions in Setting Up. This fan has a three-speed switch that lets you choose the speed best suited to your need and a switch to turn on or off the blue LED. Page 8 High if you choose to connect the fan s to a fan control device or to the Fan-Only connector found on some Antec power supplies. A fan control device regulates the fan speed by varying the voltage, which may start as low as 4.

P Connectors Not Mentioned in the Manual. How to Install a 5. How to Install an 2. GX Series 3. GX Screw Kit Information. Value Solution Series 0. ISK Series 1. Is my power supply dead? Motherboard not properly grounded to computer case. Clearing the CMOS. FAQ 6. Power Supply Comparison Chart. All manuals on ManualsCat. Make sure you choose a power supply that is compatible with and has long enough power harnesses to reach your motherboard and peripheral devices.

By Ali Tayyab. Aug 15, Share Tweet Submit. I Antec manuals Manual lost? Then search the search bar for Antec and type to find your Antec manual. Lift the rest of the fan away from the top panel. Note: there are two rear clips used to hold the fan, so you will want to lift the fan towards the front of the top panel to avoid getting snagged on them. Place the new fan onto the top panel.

The Antec logo should be on the same side as the fan grill.